A dripping tap is one of the most frequently reported domestic plumbing faults in the UK, and while it may appear a minor inconvenience, it is worth having assessed without delay. Even a slow but persistent drip wastes a measurable volume of water over days and weeks, and the internal component causing the fault will typically continue to deteriorate under normal water pressure and use, potentially making the repair more involved over time.
The cause of a dripping tap depends on its type. Traditional pillar taps — still common in older Telford properties in Wellington and surrounding areas — use a rubber washer mounted on a jumper that presses against a valve seat to create a seal.
When this washer becomes compressed or cracked with age, it no longer seals completely and water passes through even when the tap is fully closed. If the valve seat itself becomes scored or pitted, replacing the washer alone may not resolve the drip; the seat may also need to be recut or replaced.
Quarter-turn taps fitted with ceramic disc cartridges are more commonly found in properties built or refurbished from the 1990s onwards. These use two ceramic discs that rotate to allow or block water flow.
If a disc chips, cracks or accumulates limescale build-up, the tap may drip from the spout, weep around the spindle, or become stiff to operate. A plumber assessing a dripping tap will identify the tap mechanism, isolate the water supply using the nearest isolation valve or the property stopcock, remove the tap head, and inspect the internal components.
They will determine whether a new washer, cartridge, O-ring or valve seat repair is required and carry out the appropriate work. Before a plumber visits, note whether the drip is from the spout or from around the base of the spindle, which fixture is affected, and whether it is the hot or cold side that drips.
Clear the area under the sink if the isolation valve is located there.
